Sciemetric’s new partnership with Cincinnati Test Systems (CTS) marks the introduction of the...

Monitor fluid dispensing to find issues as they happen

Measuring the appropriate dispensing of sealants, coatings and adhesives can be a challenge. Typical problems are bubbles, air voids, or partial hardening due to issues such as incorrect pressure, clogged nozzles or tooling alignment. Often defects due to dispensing are not detected until much later in the assembly process.

Using a sigPOD, you can monitor the pressure of the dispensing process to ensure that it meets the accepted parameters. Find low pressure, high pressure and dispense time issues as they occur, not at the end of the line when you face higher repair and scrap costs. Sciemetric’s signature analysis systems have been used for media such as silicone beads and drops, anaerobic beads or drops, rotospray systems and to monitor oil, grease or other fluids.